Kyoritsu 8113 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Nástroje Kyoritsu 8113. KYORITSU 8113 User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 16
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
INSTRUCTION MANUAL
MODEL 8113
KEW SNAP
SERIES
KYORITSU ELECTRICAL INSTRUMENTS WORKS, LTD.,
TOKYO, JAPAN
AC/DC CLAMP ADAPTOR
Zobrazit stránku 0
1 2 3 4 5 6 ... 15 16

Shrnutí obsahu

Strany 1 - KEW SNAP

INSTRUCTION MANUALMODEL 8113KEW SNAPSERIESKYORITSU ELECTRICAL INSTRUMENTS WORKS, LTD., TOKYO, JAPANAC/DC CLAMP ADAPTOR

Strany 2 - Contents

―8――8―(2) Refer to Table 1 for output voltage against input. Set themultimeter to the appropriate range. When using a digitalmultimeter(3-1/2 digit),

Strany 3 - 1. Features

―9――9―(5) In case of DC current measurement, output is positive whenthe current flows from the upside to the underside of theclamp adaptor as shown in

Strany 4 - 2. Specifications

―10―When the battery indicator LED blinks at a longer interval andfinally stops blinking , replace the battery as indicated below.CAUTION : Do not rep

Strany 5

―11―7-1 Model 8021 KEW ENERGIZERModel 8021 ENERGIZER permits Model 8113 to make ACcurrent and voltage measurements of household electricalappliances w

Strany 6 - 3. Safety Notes

―12―7-2 Model 8008 MULTI-TRANModel 8008 MULTI-TRAN is designed to measure AC currenthigher than 200A or large bus-bars ( up to 150×100mm) andconducto

Strany 7

Kyoritsu reserves the right to change specifications or designsdescribed in this manual without notice and without obligations.

Strany 8 - 4. Instrument Layout

DISTRIBUTORPrinted in Japan92―1152A

Strany 9 - 5. Measuring Method

Page1. Features... 12. Specifications...

Strany 10

● Model 8113 is a clamp-on AC/DC current/voltage converterthat permits AC/DC current measurements from 1mA to200A in conjunction with a voltmeter havi

Strany 11

―2―2. SpecificationsAccuracy:Output Voltage:(Above accuracies are specified for + 18℃ to + 23℃ at < 80%relative humidity)OperatingTemperature& Hum

Strany 12 - 6. Battery Replacement

―3―Low BatteryWarning : Power indication lamp flashes at a longerinterval when batteries become exhaustedand finally stops flashing at approx. 2.2V.Cu

Strany 13 - 7. Optional Accessories

―4―This instruction manual contains warnings and safety rules thatmust be observed by the user to ensure safe operation of theinstrument and reta

Strany 14

―5―might be at ground potential. Keep your body isolated fromground by using dry clothing, rubber shoes, rubber mats, orany approved insulating materi

Strany 15

―6―4. Instrument Layout1 Transformer JawsPick up current flowing through the conductor.2 Jaw TriggerOperates the transformer jaws. Press to open the

Strany 16 - DISTRIBUTOR

―7――7―BEFORE USING THE ADAPTOR, READ THE SAFETYNOTES CAREFULLY AND THOROUGHLY.5-1. Preparation(1) Remove the battery compartment cover and install the

Komentáře k této Příručce

Žádné komentáře